Vmps Server - Cisco Catalyst 3030 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands

vmps server

Use the vmps server global configuration command to configure the primary VLAN Membership Policy
Server (VMPS) and up to three secondary servers. Use the no form of this command to remove a VMPS
server.
Syntax Description ipaddress
primary
Defaults
No primary or secondary VMPS servers are defined.
Command Modes Global configuration
Command History Release
12.2(25)SEE
Usage Guidelines The first server entered is automatically selected as the primary server whether or not primary is
entered. The first server address can be overridden by using primary in a subsequent command.
When using the no form without specifying the ipaddress, all configured servers are deleted. If you
delete all servers when dynamic-access ports are present, the switch cannot forward packets from new
sources on these ports because it cannot query the VMPS.
Examples This example shows how to configure the server with IP address 191.10.49.20 as the primary VMPS
server. The servers with IP addresses 191.10.49.21 and 191.10.49.22 are configured as secondary
servers:
Switch(config)# vmps server 191.10.49.20 primary
Switch(config)# vmps server 191.10.49.21
Switch(config)# vmps server 191.10.49.22
78-17262-01
vmps server ipaddress [primary]
no vmps server [ipaddress]
IP address or hostname of the primary or secondary VMPS servers. If you specify a
hostname, the Domain Name System (DNS) server must be configured.
(Optional) Decides whether primary or secondary VMPS servers are being
configured.
Modification
This command was introduced.
Cisco Catalyst Blade Switch 3030 Command Reference
vmps server
2-555