Show Link State Group - Cisco Catalyst 3030 Command Reference Manual

show link state group

show link state group
Use the show link state group global configuration command to display the link-state group
information.
Syntax Description
number
detail
Defaults
There is no default.
Command Modes Privileged EXEC
Command History Release
12.2(25)SEE
Usage Guidelines Use the show link state group command to display the link-state group information. Enter this
command without keywords to display information about all link-state groups. Enter the group number
to display information specific to the group. Enter the detail keyword to display detailed information
about the group.
Examples This is an example of output from the show link state group 1 command:
Switch> show link state group 1
Link State Group: 1
This is an example of output from the show link state group detail command:
Switch> show link state group detail
Link State Group: 1
Upstream Interfaces
Downstream Interfaces : Gi0/3(Up) Gi0/4(Up)
Link State Group: 2
Upstream Interfaces
Downstream Interfaces :
(Up):Interface up
Cisco Catalyst Blade Switch 3030 Command Reference
2-338
show link state group [number] [detail]
Modification
This command was introduced.
Status: Enabled, Up
Status: Enabled, Up
: Po1(Up)
Status: Disabled, Down
:
(Dwn):Interface Down
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
(Optional) Number of the link-state group.
(Optional) Specify that detailed information appears.
(Dis):Interface disabled
78-17262-01