Show Controllers Utilization - Cisco Catalyst 3030 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands

show controllers utilization

Use the show controllers utilization user EXEC command to display bandwidth utilization on
the switch or specific ports.
Syntax Description
interface-id
| begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2(25)SEE
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples
This is an example of output from the show controllers utilization command.
Switch> show controllers utilization
Port
Gi0/1
Gi0/2
<output truncated>
Switch Receive Bandwidth Percentage Utilization
Switch Transmit Bandwidth Percentage Utilization : 0
Switch Fabric Percentage Utilization : 0
This is an example of output from the show controllers utilization command on a specific port:
Switch> show controllers gigabitethernet0/1 utilization
Receive Bandwidth Percentage Utilization
Transmit Bandwidth Percentage Utilization
78-17262-01
show controllers [interface-id] utilization [ | {begin | exclude | include} expression]
(Optional) ID of the switch interface.
(Optional) Display begins with the line that matches the specified expression.
(Optional) Display excludes lines that match the specified expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Receive Utilization
0
0
Transmit Utilization
0
0
: 0
: 0
: 0
Cisco Catalyst Blade Switch 3030 Command Reference
show controllers utilization
2-287