Replacing A 3.5-Inch Hdd Module - Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual

Installing a 3.5-inch dummy module
CAUTION
▶
If the removed HDD module is not replaced immediately, always
replace a dummy module into the unused HDD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 62: Installing the 3.5-inch dummy module
▶ Push the dummy module into the empty bay until it engages.
Concluding steps
▶ If applicable,
"Installing the front cover with lock" on page
7.4.4

Replacing a 3.5-inch HDD module

Customer Replaceable
Unit (CRU)
Tools:
– Installation frame included: tool-less
– Installation frame excluded: Phillips PH1 / (+) No. 1 screw driver
RX1330 M5
Hard disk drive (HDD) / solid state disk (SSD)
Upgrade and Maintenance Manual
61.
Hardware: 5 minutes
131