Show Ipv6 Mld Groups - Cisco Nexus 5600 Series Reference

Show Commands

show ipv6 mld groups

To display information about the Multicast Listener Discovery (MLD) attached-group membership, use
the show ipv6 mld groups command.
Syntax Description
icmp
source
group
if-type
if-number
vrf
vrf-name
all
Defaults
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
5.0(3)N1(1)
Usage Guidelines
This command requires the Enterprise Services license.
Examples
This example shows how to display information about the MLD group membership:
switch(config)# show ipv6 mld groups
MLD Connected Group Membership for VRF "default" - 13 total entries (*, ff13::0001)
Type: Local, Interface: Ethernet2/1
Uptime/Expires: 00:00:25/00:03:54, Last Reporter: fe80::0230:48ff:fe34:0d5b
OL-31626-01
show ipv6 [icmp] mld groups [{source [group]} | {group [source]}] [if-type if-number] [vrf
{vrf-name | all}]
(Optional) Specifies ICMPv6 commands.
IPv6 source address.
(Optional) IPv6 multicast group address.
(Optional) Interface type. For more information, use the question mark (?) online
help function.
(Optional) Interface or subinterface number. For more information about the
numbering syntax for your networking device, use the question mark (?) online help
function.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies all VRFs.
Modification
This command was introduced.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
show ipv6 mld groups
MCR-93