For more information about Proxy ARP, refer to RFC 925, Multi-LAN Address Resolution, and RFC 1027, Using ARP to Implement
Transparent Subnet Gateways.
Configuration Tasks for ARP
For a complete listing of all ARP-related commands, refer to the Dell Networking OS Command Line Reference Guide.
Configuration tasks for ARP include:
•
Configuring Static ARP Entries
•
Enabling Proxy ARP
(optional)
•
Clearing ARP Cache
(optional)
•
ARP Learning via Gratuitous ARP
•
ARP Learning via ARP Request
•
Configuring ARP Retries
Configuring Static ARP Entries
ARP dynamically maps the MAC and IP addresses, and while most network host support dynamic mapping, you can configure an
ARP entry (called a static ARP) for the ARP cache.
To configure a static ARP entry, use the following command.
•
Configure an IP address and MAC address mapping for an interface.
CONFIGURATION mode
arp vrf vrf-name ip-address mac-address interface
– vrf vrf-name: use the VRF option to configure a static ARP on that particular VRF.
– ip-address: IP address in dotted decimal format (A.B.C.D).
– mac-address: MAC address in nnnn.nnnn.nnnn format.
– interface: enter the interface type slot/port information. For 10G interfaces, enter the slot/port information.
Example of the show arp Command
These entries do not age and can only be removed manually. To remove a static ARP entry, use the no arp ip-address
command.
To view the static entries in the ARP cache, use the show arp static command in EXEC privilege mode.
Dell#show arp
Protocol
Address
--------------------------------------------------------------------------------
Internet
10.1.2.4
Dell#
Enabling Proxy ARP
By default, Proxy ARP is enabled. To disable Proxy ARP, use the no proxy-arp command in the interface mode.
To re-enable Proxy ARP, use the following command.
•
Re-enable Proxy ARP.
INTERFACE mode
ip proxy-arp
410
IPv4 Routing
(optional)
Age(min) Hardware Address
17
08:00:20:b7:bd:32
Interface VLAN CPU
Ma 1/1
-
CP