Add Or Remove A Port Channel From A Vlan - Dell Force10 Z9000 Configuration Manual

Configure the minimum oper up links in a port channel (LAG)
You can configure the minimum links in a port channel (LAG) that must be in "oper up" status for the port
channel to be considered to be in "oper up" status. Use the following command in the INTERFACE mode:
Command Syntax
minimum-links number
Figure 19-15
Figure 19-15. Example of using the minimum-links Command
FTOS#config t
FTOS(conf)#int po 1
FTOS(conf-if-po-1)#minimum-links 5
FTOS(conf-if-po-1)#

Add or remove a port channel from a VLAN

As with other interfaces, you can add Layer 2 port channel interfaces to VLANs. To add a port channel to a
VLAN, you must place the port channel in Layer 2 mode (by using the
To add a port channel to a VLAN, use either of the following commands:
Command Syntax
tagged port-channel id number
untagged port-channel id number
To remove a port channel from a VLAN, use either of the following commands:
Command Syntax
no tagged port-channel id number
no untagged port-channel id number
To see which port channels are members of VLANs, enter the
mode.
| Interfaces
392
Command Mode
INTERFACE
displays an example of configuring five minimum "oper up" links in a port channel.
Command Mode
INTERFACE
VLAN
INTERFACE
VLAN
Purpose
Enter the number of links in a LAG that must be in "oper
up" status.
Default: 1
Purpose
Add the port channel to the VLAN as a tagged
interface. An interface with tagging enabled can
belong to multiple VLANs.
Add the port channel to the VLAN as an untagged
interface. An interface without tagging enabled can
belong to only one VLAN.
Command Mode Purpose
INTERFACE
Remove the port channel with tagging enabled
VLAN
from the VLAN.
INTERFACE Remove the port channel without tagging
VLAN enabled from the VLAN.
show vlan
switchport
command).
command in the EXEC Privilege