Tandberg Configuration; Manually Assign An Ip Address - Avaya TANDBERG 150 MXP Installation Instructions Manual

4. Tandberg Configuration

This section describes the steps for configuring the Tandberg endpoints. The configuration of the
Tandberg endpoints may be administered via the keypad of the Tandberg endpoint or the
Command Line Interface (CLI).

4.1. Manually Assign an IP Address

Assigning or changing the IP address of the T150 will generally be the first configuration task
performed on a system. The T150 supports the use of DHCP and DHCP is enabled by default.
If use of DHCP is appropriate, then the steps in this section would not be required.
Note: IP address change requires a restart of the system and it could be difficult to recover from a
configuration error if the change is performed over telnet.
Step Description
1. Press the Settings key on the T150. If prompted for the Administrator Password, enter
it using the numeric keypad and press the
Menu will be presented.
2. Use the directional key to scroll to and highlight the Network item and press the
display the Network menu.
3. Use the directional key to scroll to and highlight the IP Settings item and press the
to display the IP Settings screen.
Issue 1.0
1/10/2008
Figure 4 - Bottom View of TANDBERG 150 MXP
2008 Avaya Inc. All Rights Reserved.
key (check mark icon). The Administrator
key to
key
10 of 13