Configure Ports Link-Detection-Level - Extreme Networks ExtremeWare Command Reference Manual

configure ports link-detection-level

configure ports <portlist> link-detection-level <link-detection-level>
Description
Configures the link detection level.
NOTE
This command is available only on the "i" series switches.
Syntax Description
portlist
link-detection-level
Default
The default link detection level is 2.
Usage Guidelines
The range is 1 - 4. Table 9 lists the behavior of the switch at each level.
Table 9: Link detection level behavior
Level ISR
1 off
2 on
3 off
4 on
Example
The following command configures the link detection level for port 3 to 4:
configure ports 3 link-detection-level 4
History
This command was first available in ExtremeWare 6.2.2.
Platform Availability
This command is only available on the "i" series platform.
ExtremeWare 7.7 Command Reference Guide
Specifies one or more primary ports or slots and ports. On a modular switch, can be a list
of slots and ports. On a stand-alone switch, can be one or more port numbers. May be in
the form 1, 2, 3-5, 2:*, 2:5, 2:6-2:8.
Specifies a link detection level.
Middle Layer Filter
off
off
on
on
configure ports link-detection-level
281