Configure Ports Auto On - Extreme Networks ExtremeWare Command Reference Manual

configure ports auto on

configure ports [<portlist> | mgmt | all] auto on {speed [10 | 100 | 1000]}
Description
Enables autonegotiation for the particular port type.
Syntax Description
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a list of slots and ports.
On a stand-alone switch, can be one or more port numbers. May be in the form 1, 2, 3-5, 2:*, 2:5,
2:6-2:8.
mgmt Specifies the management port. Supported only for switches that provide a management port.
all Specifies all configured ports on the switch. (6.1 and later) See "Usage Guidelines" for more
information.
speed Specifies the speed of the port. Values are: 10, 100, 1000.
Applicable only on Summit 400 series. Auto negotiation is not supported on 10 Gigabit ports.
Default
Auto on
Usage Guidelines
On a modular switch,
can be one or more port numbers. For a detailed explanation of port specification, see "Modular Switch
Numerical Ranges" or "Stand-alone Switch Numerical Ranges" in Chapter 1.
The type of ports enabled for autonegotiation are 802.3u for 10/100 Mbps ports or 802.3z for Gigabit
Ethernet ports.
On Summit 400 series switches you can set the speed of the port. If you set the speed, the switch auto
negotiates only the duplex mode.
For "i" series only: Flow control is supported on Gigabit Ethernet ports only. It is enabled or disabled
as part of autonegotiation. If autonegotiation is set to off, flow control is disabled. When autonegotiation
is turned on, flow control is enabled.
For version 6.1: •The
Example
The following command configures the switch to autonegotiate for ports 4 and 6 on a stand-alone
switch:
configure ports 4,6 auto on
The following command configures the switch to autonegotiate for slot 1, ports 2 and 4 on a modular
switch:
configure ports 1:2, 1:4 auto on
ExtremeWare 7.7 Command Reference Guide
can be a list of slots and ports. On a stand-alone switch,
<portlist>
parameter specifies all ports on the switch.
all
configure ports auto on
<portlist>
277