Configure Account - Extreme Networks ExtremeWare Command Reference Manual

Commands for Accessing the Switch

configure account

configure account <user account> {encrypted} {<password>}
Description
Configures a user account password.
Syntax Description
user account Specifies a user account name.
encrypted This option is for use only by the switch when generating an ASCII configuration file. Specifies
that the password should be encrypted when the configuration is uploaded to a file. Should not
be used through the CLI.
password Specifies a user password. Supported in ExtremeWare 4.x and ExtremeWare 6.0.x only. In
ExtremeWare 6.1 and later, the switch prompts for entry of the password interactively.
Default
N/A
Usage Guidelines
You must create a user account before you can configure a user account. Use the
command to create a user account.
You must have administrator privileges to change passwords for accounts other than your own. User
names and passwords are case-sensitive.
The option is used by the switch when generating an ASCII configuration file (using the
encrypted
upload configuration
download configuration
For ExtremeWare 6.1 and higher:
• The password cannot be specified on the command line. Instead, the switch will interactively prompt
you to enter the password, and will then prompt you to reenter the password to verify that you have
entered it correctly.
For ExtremeWare 6.0 and higher:
• Passwords must have a minimum of 1 character and can have a maximum of 30 characters.
For ExtremeWare 4.x:
• Passwords must have a minimum of 4 characters and can have a maximum of 12 characters.
76
command), and parsing a switch-generated configuration file (using the
command). Do not select the encrypted option in the CLI.
create account
ExtremeWare 7.7 Command Reference Guide