Mping, Start Ping Execution (Icmp Protocol) - Motorola G24 Guide Developer's Manual

+MIPRTCP:
2,130,484541443E3C5449544C453E333032204D6F7665643C2F5449544C453E3C2F484541443E3C424F44
593E0A3C48313E333032204D6F7665643C2F48313E0A54686520646F63756D656E7420686173206D
+MIPRTCP:
2,50,6F7665640A3C4120485245463D22687474703A2F2F7777772E676F6F676C652E636F2E696C2F63786
665723F633D505245462533443A544D253344313131393531343833323A5325334467384A637631
+MIPRTCP:
2,0,426A5458472D30636A5926616D703B707265763D2F223E686572653C2F413E2E0D0A3C2F424F44593
E3C2F48544D4C3E0D0A
+MIPSTAT: 2,1,40

+MPING, Start Ping Execution (ICMP Protocol)

This command allows to verify IP connectivity to another remote machine (computer) by sending
one or more Internet Control Message Protocol (ICMP) Echo Request messages. The receipt of
corresponding Echo Reply messages are displayed, along with round trip times.
Valid IP address must be obtained using AT+MIPCALL command prior to starting ping
execution.
Only one ping request execution will be allowed at any given moment.
Command Type
Set
Unsolicited
Response
December 31, 2007
Syntax
+MPING=<mode OK
>[,<"Destination
or:
IP/hostname">[,<
+CME ERROR: <err>
count>
[,<size>[,<TTL>[,
<TOS>
[,<TimeOut>]]]]]]
+MPING:
<"Destination IP">,<type>,<code>
[,<RTT>]
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Response/Action Remarks
The set command
shall send a <count>
Internet Control
Message Protocol
(ICMP) Echo Request
messages to a target
node defined by
<"Destination
IP/hostname">
parameter.
If <mode> is equal 0,
no parameters trailing
<mode> parameter
are allowed,
otherwise ERROR
message will be
reported to DTE. If
<mode> is equal 0,
MS will abort sending
Echo Request
messages if ping
request is in process,
otherwise ERROR
message will be
reported to DTE.
The receipt of
corresponding ICMP
Echo Reply messages
will be displayed
within unsolicited
responses, along with
round trip times.
3-405