Motorola G24 Guide Developer's Manual page 597

Q
READY
RING
S102
S24
S94
S96
Sn
T
V
X
Y
Z
December 31, 2007
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command
This command determines
whether to output/suppress the
result codes.
This unsolicited notification
indicates UART is ready.
This unsolicited event is received
when an incoming call (voice,
data or fax) is indicated by the
cellular network.
This S-register sets the value of
the delay before sending the data
to the terminal.
This S-parameter
activates/disables the Sleep
mode. If the parameter value is
greater than 0, it represent the
number of seconds till the G24
enters sleep mode.
This S-parameter represents the
Boolean status, On/Off, of the
sidetone feature.
This S-parameter represents the
Boolean status, On/Off, of the
echo cancelling feature in the
handsfree.
This command reads/writes
values of the S-registers, and
includes registers 1-49.
This command is supported for
backward compatibility only, and
has no effect.
This command determines the
response format of the data
adapter and the contents of the
header and trailer transmitted
with the result codes and
information responses.
This command defines the data
adaptor response set, and the
CONNECT result code format.
This command is supported for
backward compatibility only, and
has no effect.
This command resets the default
configuration.
AT Commands Reference Manual
Appendix A: Reference Tables
Description
Page 3-274
Page 3-211
Page 3-19
Page 3-286
Page 3-285
Page 3-235
Page 3-236
Page 3-277
Page 3-422
Page 3-273
Page 3-276
Page 3-422
Page 3-282
Page
A-21