Mamut, Input Devices Mute - Motorola G24 Guide Developer's Manual

Audio

+MAMUT, Input Devices Mute

This command controls the muting/unmuting of all input paths (mic, headset mic or digital RX).
Upon power up, all the devices are unmuted.
Command
Type
Set
Read
Test
The following table shows the +MAMUT parameters.
Example
AT+MAMUT=2,0//Accy=2 (headset mic), state=0 (unmute)
OK
AT+MAMUT=5,1//Accy=5 (mic + Digital RX), state=1 (mute)
OK
AT+MAMUT?
+MAMUT: 1,1//Accy=1 (mic), state=1 (mute)
+MAMUT: 2,0//Accy=2 (headset mic), state=0 (unmute)
+MAMUT: 4,1//Accy=4 (Digital RX), state=1 (mute)
AT+MAMUT=?
+MAMUT: (1-7),(0,1)
OK
3-242
Syntax Response/Action
+MAMUT=<accy>, OK
<state>
or:
+CME ERROR: <err>
+MAMUT? +MAMUT:<accy1>,<state>
+MAMUT:<accy2>,<state>
+MAMUT:<accy4>,<state>
OK
+MAMUT=? +MAMUT:(<accy>
range),(<state> range)
Table 3-158: MAMUT Parameters
<Parameter>
<accy> (1-7)
1 Mic
2 Headset mic
4 Digital RX
<state>
0 Unmute
1 Mute
AT Commands Reference Manual
Remarks
The Set command mutes/unmutes
any input accessory or any
combination of them.
The Read command returns the
current mute/unmute state of all the
input accessories.
The Test command returns the mute
states available and the output
accessories supported.
Description
December 31, 2007