Cscb, Cell Broadcast Messages - Motorola G24 Guide Developer's Manual

+CSCB, Cell Broadcast Messages

This command handles the selection of cell broadcast message types and data coding schemes
received by the G24.
Command Type
Set
Read
Test
Note:
December 31, 2007
If after aborting AT+CMGS command execution and before result of operation was
reported by G24, a second AT+CMGS command is executed, then the result of the second
AT+CMGS operation only will be reported by G24.
Syntax
+CSCB=[<mode>
[,<mids>[,<dcss>]
]]
+CSCB?
+CSCB=?
The Channel and DCS list is saved to the SIM card.
The maximum number of active channels is SIM dependent.
The AT+CSCB set command is not available when the phone is either in "Emergency
Only" or "No Service" status.
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Response/Action
If mode=0 and <mids> The Set command sets the cell
is not specified, then broadcast message type and data
no channels are coding scheme.
accepted, and the g24
channel/mid list is
cleared.
If mode=1 and <mids>
is not
specified, then
the G24 channel list will
stay as is.
OK
or:
+CME ERROE:<err>
+CSCB: The Read command displays the
current MID and DCS settings.
<mode>,<mids>,<dcss>
+CSCB: (list of The Test command displays the
supported values of <mode>.
supported <mode>s)
Remarks
3-135