Motorola G24 Guide Developer's Manual page 189

<Parameter>
<pid>
<dcs>
<Parameter>
0 to 143
144 to 167
168 to 196
197 to 255
Example
AT+CSMP?
+CSMP: 17,167,0,0 (default values for SMS-SUBMIT)
OK
AT+CSMP= 1,256,0,0
+CMS ERROR: numeric parameter out of bounds
AT+CSMP=29,"04/11/04,09:48:36+08"
OK
AT+CSMP=?
OK
AT+CSDH=1
OK
AT+CMGF=1
OK
AT+CMGW="0544565034"
> ABC (^Z)
+CMGW: 160
OK
AT+CMGR=160
+CMGR: "STO UNSENT","0544565034",,81,29,0,0,"04/11/04,09:48:36+08","+97254120032",145,3
ABC
OK
December 31, 2007
Table 3-56: +CSMP Parameters (Cont.)
Protocol-Identifier. The one octet information element by which the SM-TL either
refers to the higher layer protocol being used, or indicates interworking with a certain
type of telematic device.
"0 - no interworking, SME-to-SME protocol (default)
"Any value between 0-255 will be accepted.
The SC may reject messages with a TP-Protocol-Identifier containing a reserved
value or one, which is not supported.
One octet of Data Coding Scheme, indicates the data coding scheme of the DATA,
and may indicate a message class.
NOTE:
For DCS expanded information, see section
default alphabet: 00xx00xx, 111100xx, 1101xxxx
8 bit data: 00xx01xx, 111101xx
UCS2: 00xx10xx, 1110xxxx
reserved: 00xx11xx, 0100xxxx-1011xxxx
The default value at power-up is 0 - Default alphabet.
Table 3-57: VP Relative Format (In Integer Frmat)
(TP-VP + 1) x 5 minutes (i.e. 5 minutes intervals up to 12 hours)
12 hours + ((TP-VP - 143) x 30 minutes)
(TP-VP - 166) x 1 day
(TP-VP - 192) x 1 week
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Description
"DCS handling" on page
Description
3-144.
3-105