Memse, Send Email Message - Motorola G24 Guide Developer's Manual

Email

+MEMSE, Send Email Message

This AT command is used to connect to mail server in order to Send the email massages to the
G24 memory. In case the <notification> parameter is set to ON, the unsolicited message will be
printed to the TE with connection status.
Command
Type
Set
Unsolicited
Report
Test
The following table shows the +MEMSE parameters.
<Parameter>
<notification>
<message_id>
<status>
3-156
Syntax
AT+MEMSE=<message_id>
[,notification>]
AT+MEMSE=?
Table 3-94: +MEMSE Parameters
0 - Unsolicited report for sending status is disabled.
1 - Unsolicited report for sending status is enabled.
The default value is 0.
Integer type - Message identifier number to send.
Integer value. Notification for the receiving status.
See Table 3-95.
AT Commands Reference Manual
Response/Action
OK
Or:
+CME ERROR: <err>
+MEMSE: <status> In case of active unsolicited
report (notification equals
to `1`).
+MEMSE: (list of
supported <notification>
values)
Description
Remarks
December 31, 2007