Motorola G24 Guide Developer's Manual page 60

AT Commands Summary
AT Command
+MEMR
+MEMW
Network
Network Commands
+CSQ
+CRLP
+CREG
+CGREG
+COPS
+CPOL
+MFS
+MCELL
Hardware Information
Hardware Information Commands
+CBC
+CBAUD
+IPR
+GCAP
+CBAND
+MTDTR
+MTCTS
&K
&C
&D
1-26
Table 1-1: AT Commands (Cont.)
Description
This command is used to read an Email message.
This command is used to write or update an Email message.
This command displays the signal strength received by the G24.
This command displays the Radio Link Protocol parameters.
This command enables/disables the network status registration
unsolicited result code.
This command enables/disables the GPRS network status
registration unsolicited result code.
This command enables accessing the network registration
information, as well as select and register the GSM network
operator.
This command is used to edit the list of preferred operators located
in the SIM card.
This command is used to determine how long the G24 waits before
attempting to re-register after a registration attempt has failed and
the G24 is not registered.
This command displays information about the Cellular Network.
This command queries the battery charger connection.
This command sets the baud rate.
This command is responsible for setting and saving the request baud
rate.
This command displays the overall capabilities of the G24.
This command is supported for backward compatibility only, and
has no effect.
This command checks and displays the physical current status of the
DTR pin of the RS232.
This command sets the CTS pin of the RS232 to not active (high),
waits one second and then sets the CTS to active (low).
This command configures the RTS/CTS flow control.
This command determines how the state of the DCD line relates to
the detection of the received line signal from the distant end.
This command determines how the G24 responds when the DTR
(Data Terminal Ready) status is changed from ON to OFF during
the online data state.
AT Commands Reference Manual
Page
Page 3-162
Page 3-165
Page 3-167
Page 3-168
Page 3-169
Page 3-171
Page 3-172
Page 3-175
Page 3-177
Page 3-179
Page 3-193
Page 3-194
Page 3-195
Page 3-197
Page 3-280
Page 3-197
Page 3-198
Page 3-198
Page 3-199
Page 3-201
December 31, 2007