Motorola G24 Guide Developer's Manual page 222

SMS
The following table shows the +MCSAT parameters.
<Parameter>
<mode>
<dcs_mask>
3-138
Table 3-83: +MCSAT Parameters
0 Suppress alert tone
1 Enable alert tone
2 Play alert tone
The default value at power-up is 1.
SMS data coding-scheme mask. The format is an 8-bit information parameter. Each
bit contains 0, 1, or X (ASCII character):
0 Condition is met if the arriving SMS includes dcs with 0 in this position
1 Condition is met if the arriving SMS includes dcs with 1 in this position
X or x This bit is ignored from the dcs of the arriving SMS
AT Commands Reference Manual
Description
December 31, 2007