Motorola G24 Guide Developer's Manual page 78

Core AT Commands
AT Command
&Y
?
\A
\B
\G
\J
\K
\N
\S
+CBAUD
+CEER
+CFSN
+CFUN
+CGEQMIN
+CGEQNEG
+CGEQREQ
+CGMI
+CGMM
+CGMR
+CGSN
+CHUP
+CIND
+CKPD
+CLAC
2-10
Table 2-1: Core AT Commands (Cont.)
Description
This command displays the default user profile.
This command displays the most recently updated value stored in
the S-register.
This command is supported for backward compatibility only, and
has no effect.
This command is supported for backward compatibility only, and
has no effect.
This command sets the use of the software flow control.
This command adjusts the terminal auto rate.
This command is supported for backward compatibility only, and
has no effect.
This command displays the link type.
This command displays the status of selected commands and
S-registers.
This command sets the baud rate.
This command returns an extended error report containing one or
more lines of information text, determined by the manufacturer,
providing the reasons for the call- clearing errors.
This command displays the factory serial number.
This command shuts down the phone functionality of smart phones
and PDAs with phone capabilities.
This command allows the TE to specify a minimum acceptable
profile, which is checked by the MT against the negotiated profile
returned in the Activate/Modify PDP Context Accept message.
This command allows the TE to retrieve the negotiated QoS
profiles returned in the Activate PDP Context Accept message.
This command allows the TE to specify a EDGE Quality of Service
Profile that is used when the MT sends an Activate PDP Context
Request message to the network.
This command displays manufacturer identification.
This command requests the model identification.
This command requests the revision identification.
This command requests the product serial number identification.
This command causes the G24 to hang up the current GSM call.
This command is used to query the status of various ME indicators.
This command emulates key presses, or virtual keycodes, as if
entered from the G24 keypad or from a remote handset.
This command displays a list of all the AT commands supported by
the G24.
AT Commands Reference Manual
Page
Page 3-310
Page 3-281
Page 3-422
Page 3-422
Page 3-280
Page 3-280
Page 3-422
Page 3-280
Page 3-280
Page 3-194
Page 3-296
Page 3-6
Page 3-204
Page 3-346
Page 3-352
Page 3-340
Page 3-1
Page 3-2
Page 3-3
Page 3-3
page 3-35
Page 3-316
Page 3-310
Page 3-9
December 31, 2007