Motorola G24 Guide Developer's Manual page 80

Core AT Commands
AT Command
+GMM
+GMR
+GSN
+IFC
+IPR
+MADIGITAL
+MAFEAT
+MAMUT
+MAPATH
+MAVOL
+MCEG
+MCELL
+MCST
+MCWAKE
+MDLC
+MIAU
+MSCTS
+MDC
+MDSI
+MEDT
+MEMAS
+MEMD
+MEMDE
+MEMISP
+MEMGS
2-12
Table 2-1: Core AT Commands (Cont.)
Description
This command requests the model identification.
This command requests the revision identification.
This command requests the product serial number identification.
This command controls the operation of the local flow control
between the terminal and the G24.
This command is responsible for setting and saving the request
baud rate.
This command switches between analog and digital audio modes.
This command controls the various algorithm features, such as
sidetone, echo cancel and noise suppress.
This command controls the muting/unmuting of all input paths
(MIC, HDST_MIC, DIGITAL_RX).
This command sets/requests the active input accessory, and the
output accessory for each feature.
This command enables you to determine a volume setting for a
particular feature in a particular accessory.
This command disables / enables EDGE support in G24 modules
with EDGE support capability.
This command displays information about the Cellular Network.
This command displays the current state of the call processing, and
also enables/disables the unsolicited indication of any change in the
call processing state.
This command displays reports on the status of the GPRS/GSM
coverage.
This command establishes PPP link over serial port.
This command manages IP Director addresses and port.
This command defines the behavior of the CTS line when the G24
is in Sleep mode.
This command enables you to select the desired messages to be
displayed upon connection of a voice call with a remote party.
This command enables unsolicited reporting of indications of SIM
deactivation and invalidation.
This command enables/disables the G24 tones.
This command is used for Email account settings.
This command is used to delete an Email message.
This command is used to download an Email message.
This command is used for Email account ISP settings.
This command is used for Email account general settings.
AT Commands Reference Manual
Page
Page 3-2
Page 3-3
Page 3-3
Page 3-430
Page 3-195
Page 3-244
Page 3-243
Page 3-242
Page 3-237
Page 3-240
Page 3-356
Page 3-179
Page 3-49
Page 3-202
Page 3-337
Page 3-338
Page 3-288
Page 3-38
Page 3-78
Page 3-139
Page 3-150
Page 3-163
Page 3-154
Page 3-149
Page 3-152
December 31, 2007