Ready, Unsolicited Notification (Uart Ready Indication); Mpsu, Motorola Physical Second Uart - Motorola G24 Guide Developer's Manual

Operation of this command is flex dependent.
Command
Type
Read
The following table shows the +TADIAG parameters.
<Parameter>
<RF1_value>
<RF2_value>
Example
AT+TADIAG?
+TADIAG: 0,0
OK
AT+TADIAG?
+TADIAG: 75,0
OK

READY, Unsolicited Notification (UART Ready Indication)

The READY unsolicited notification is sent to the TE following radio power-up, when the UART
is ready for communication, as indicated by DSR line state. This unsolicited notification is flex
dependant.

+MPSU, Motorola Physical Second Uart

This command defines the functionality of the second physical UART.
The command is a basic command.
This feature is active by default.
UART2 has only 4 standard RS232 physical lines for serial communications: Tx, Rx, CTS and
RTS.
December 31, 2007
Syntax Response/Action
AT+TADIAG? +TADIAG:
<RF1_value>,<RF2_value>
OK
or:
+CME ERROR <error>
Table 3-138: +TADIAG Parameters
0-255 ADC value reading of primary antenna.
0-255 ADC value reading of secondary antenna.
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Remarks
Description
3-211