Motorola G24 Guide Developer's Manual page 148

Call Control
5
6
7
8
9
Example
AT+CSSN=?// test command
+CSSN: (0-1),(0-1)
OK
AT+CSSN=0,0// disable both options
OK
AT+CSSN=1,0// set n value as enabled, m disabled
OK
AT+CSSN?
+CSSN: 1,0// display the current n & m values
OK
+CSSI: 1// displayed after mobile originated call setup of call forward and n enable
+CSSU: 2//displayed when a call has been placed on hold (during the call) using the +CHLD AT command
and m enable
3-64
Table 3-33: +CSSU Notification Values (Cont.)
Value
Call on hold has been released
(during a voice call; not a
supplementary service
notification)
Forward check supplementary
service message received (can be
received at any time)
Call is being connected with the
remote party in an alerted state
using an explicit call transfer
operation (during a voice call).
Call has been connected with the
other remote party using an
explicit call transfer operation
(during a voice call or during
mobile-terminated call setup).
Number and subaddress
parameters may be present:
<number>String type phone
number of format defined by
<type>
<type>Type of address octet in
integer format (refer to GSM
04.08 [8], subclause 10.5.4.7)
<subaddr>String type subaddress
of format defined by <satype>
<satype>Type of subaddress
octet in integer format (refer to
GSM 04.08 [8], subclause
10.5.4.8)
Deflected call
(mobile-terminated call setup)
AT Commands Reference Manual
Description
Yes
Yes
Yes
Yes
No
G24 Support
December 31, 2007