At Commands Protocol & Structure Configuration - Motorola G24 Guide Developer's Manual

AT Commands Protocol & Structure Configuration
The AT commands message flow and structure may be configured by the terminal.
The G24 can be configured not to follow a command with an echo and/or results code. It can be
configured to transmit the results code in either of two ways: Verbose or Numeric. This (and
other) configurations can be set using the following commands:
S3=[<value>]
S4=[<value>]
S5=[<value>]
E[<value>]
Q[<value>]
V[<value>]
X[<value>]
The figure below shows the flow and structure configuration commands:
Figure 2-4: Flow and Structure Configuration Commands
December 31, 2007
Command
Command line termination character (default setting 0x13).
Response formatting character (default 0x10).
Command line editing character (default 0x 8).
Command echo (default 0, meaning the G24 does not echo commands).
Result code suppression (default 0, meaning the G24 transmits result
codes).
G24 response format (default 1, meaning verbose format).
Defines CONNECT result code format.
A T C
ATEx A T C
ATQx <CR> <LF>
ATS5=x
A T T
A T C
<CR> <LF>
AT Commands Reference Manual
Chapter 2: Introduction to AT Commands
Description
ATS3=x
M D 2 1 2 <CR>
=
M D 2 1 2 <CR>
=
O K <CR> <LF>
ATVx ATS4=x
C M D 1 <CR>
M D 1 <CR>
O K <CR> <LF>
2-5