Fpr, Fax Serial Port Rate - Motorola G24 Guide Developer's Manual

Fax Class 1

+FPR, Fax Serial Port Rate

This command sets the request baud rate. +FPR command is implemented as additional syntax to
the standard +IPR command in order to inter-work with existing Facsimile DTE.
Command Type
Set
Read
Test
The following table shows the +FPR parameter.
<Parameter>
<n>
3-432
Syntax Response/Action
+FPR=<n> OK
or:
+CME ERROR: <err>
+ FPR? +FPR: <n>
OK
Or
+FPR:255
OK
+ FPR=? +FPR: (list of
supported <n>s)
OK
or:
+CME ERROR: <err>
Table 3-288: +FPR Parameter
0 Automatic baudrate
1 Set baudrate to 2400
2 Set baudrate to 4800
4 Set baudrate to 9600
8 Set baudrate to 19200
10 Set baudrate to 38400
18 Set baudrate to 57600
20 Set baudrate to 115200
AT Commands Reference Manual
Remarks
The set command changes the baud
rate of G24 to the requested value. The
specified rate takes effect following
the issuing of any result code(s)
associated with the current command
line.
The UART is configured to the
specific requested baud rate.
The read command returns the actual
baud rate. The Report 255 is output in
cases where setting baud rate is not
supported by FPR command.
The test command returns the possible
ranges of <n>s.
Description
December 31, 2007