Motorola G24 Guide Developer's Manual page 461

Call Disconnected Event
Location Status Event
User Activity Event
Idle Screen Available Event
Card Reader Status Event
Language Selection Event
Browser Termination Event
Data Available Event
Channel Status Event
Command Type
Set
Test
December 31, 2007
Table 3-254: Current Event Types (Cont.)
Event
Performed by G24; no indication sent to the TE.
Performed by G24; no indication sent to the TE.
Initiated by TE and reported via +MTKP command. TE is
responsible for deciding what triggers this event. Only the event
occurrence is monitored by G24; no additional information is
required.
Initiated by TE and reported via +MTKP command. TE is
responsible for deciding what triggers this event. Only the event
occurrence is monitored by G24; no additional information is
required.
Issued by message handler of SCIM_CARD_DETECT_IND_ID
message. Performed by G24; no indication sent to the TE.
TE is responsible for deciding what triggers this event. +MTKP
command contains a data portion with language code – a pair of
alphanumeric characters (defined in ISO 639 [29]), each of which is
coded on one byte using the SMS default 7-bit coded alphabet, as
defined in TS 23.038, with bit 8 set to 0.
Initiated by TE and reported via +MTKP command. The command
contains a data portion that includes the cause of termination:
0
1
TE is responsible for deciding what triggers this event.
Performed by G24; no indication sent to the TE.
Performed by G24; no indication sent to the TE.
Syntax
+MTKP=16,<result
>[,<Data>]
+MTKP=?
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Notes
User terminated
Error terminated
Response/Action
OK
or:
+CME ERROR: <err>
OK
Remarks
The Set command
defines the event type.
3-377