Motorola G24 Guide Developer's Manual page 428

GPRS/EDGE
<Delivery order>
<Maximum SDU size>
<SDU error ratio>
<Residual bit error ratio>
<Delivery of erroneous SDUs>
<Transfer delay>
<Traffic handling priority>
<PDP_type>
3-344
Table 3-224: +CGEQREQ Command Parameters (Cont.)
<Parameter>
AT Commands Reference Manual
Description
Numeric parameter that indicates whether the EDGE
bearer shall provide in-sequence SDU delivery or not.
0 - no
1 - yes
2 - subscribed value.
Other values are reserved.
<Maximum SDU size>: a numeric parameter (1,2,3,...)
that indicates the maximum allowed SDU size in octets.
If the parameter is set to '0' the subscribed value will be
requested.
Numeric parameter (1,2,3,...) that indicates the
maximum allowed SDU size in octets. If the parameter
is set to '0' the subscribed value will be requested.
String parameter that indicates the target value for the
fraction of SDUs lost or detected as erroneous. SDU
error ratio is defined only for conforming traffic. The
value is specified as 'mEe'. As an example a target SDU
-3
error ratio of 5x10 would be specified as '5E3' (e.g.
AT+CGEQREQ=...,"5E3",...). '0E0' means subscribed
value.
String parameter that indicates the target value for the
undetected bit error ratio in the delivered SDUs. If no
error detection is requested, Residual bit error ratio
indicates the bit error ratio in the delivered SDUs. The
value is specified as 'mEe'. As an example a target
residual bit error ratio of 5x10
'5E3' (e.g. AT+CGEQREQ=...,"5E3",...). '0E0' means
subscribed value.
Numeric parameter that indicates whether SDUs
detected as erroneous shall be delivered or not.
0 - no
1 - yes
2 - no detect
3 - subscribed value
Numeric parameter (0,1,2,...) that indicates the targeted
time between request to transfer an SDU at one SAP to
its delivery at the other SAP, in milliseconds. If the
parameter is set to '0' the subscribed value will be
requested.
Numeric parameter (1,2,3,...) that specifies the relative
importance for handling of all SDUs belonging to the
EDGE bearer compared to the SDUs of other bearers. If
the parameter is set to '0' the subscribed value will be
requested.
(See +CGDCONT command).
If a value is omitted for a particular class then the value
is considered to be unspecified.
-3
would be specified as
December 31, 2007