Network
+CRLP, Radio Link Protocol
This command displays the Radio Link Protocol parameters that are used when non-transparent
data calls are originated.
Command
Type
Set
Read
Test
The following table shows the +CRLP parameters.
<Parameter>
<iws>
<mws>
<T1>
<N2>
Example
AT+CRLP=?
+CRLP: (010-061),(010-061),(048-255),(006-010)
OK
AT+CRLP?
+CRLP: 061,061,048,006
OK
3-168
Syntax
+CRLP=
OK
[<iws>[,<mws>[,<T1>
or:
[,<N2>]]]]
+CME ERROR: <err>
+CRLP?
+CRLP= <iws>,<mws>,<T1>,<N2>
OK
or:
+CME ERROR: <err>
+CRLP=?
+CRLP= (list of supported <iws>s),
(list of supported <mws>s), (list of
supported <T1>s), (list of supported
<N2>s)
OK
or:
+CME ERROR: <err>
Table 3-101: +CRLP Parameters
IWF to MS window size.
The default value is 61.
MS to IWF window size.
The default value is 61.
Acknowledgement timer T1.
The default value is 48.
Retransmission attempts N2 in integer format (refer to GSM 04.22 [18] subclause
5.4.3)
The default value is 6.
AT Commands Reference Manual
Response/Action
Description
Remarks
The Set command enables
you to change the RLP
parameters.
December 31, 2007