Modem Configuration and Profile
S12
This command handles the selection of the guard time, which is stored in S-Register 12, and
specifies the behavior of escape characters during CSD connection.
Note:
Command
Type
Set
Read
The following table shows the S12 parameters.
<Parameter>
<guard_time>
\S, Show the Status of the Commands and S-registers in Effect
This command displays the status of selected commands and S-registers.
\G, Software Control
This command sets the use of the software control. It is used for backward compatibility.
\J, Terminal Auto Rate
This command adjusts the terminal auto rate. It is used for backward compatibility.
\N, Link Type
This command displays the link type. It is used for backward compatibility.
+CBAND, Change Radio Band
This command has no effect, and only returns OK. It is used for backward compatibility.
3-280
For a guard time specified by S-Register 12, no character should be entered before or after
"+++". The duration between escape codes must be smaller than the guard time.
Syntax
S12=<guard_time>
OK
+CME ERROR: <err>
S12?
<guard_time>
OK
+CME ERROR: <err>
Table 3-186: S12 Parameters
CSD escape character guard time (units of 50 msec).
Range is 0 to 255. The default value is 20.
AT Commands Reference Manual
Response/Action
The Set command sets the CSD escape
character guard time value if all
parameters are valid.
The Read command displays the
current CSD escape character guard
time.
Description
Remarks
December 31, 2007