Motorola G24 Guide Developer's Manual page 140

Call Control
Command
Type
Set
Read
Test
The following table shows the +CAOC parameters.
<Parameter>
<mode>
Note:
Example
Example with prepaid SIM card with 56700.00L prepaid before the test.
AT
OK
AT+CAOC=2
OK
atd+97254565190;
OK
OK
+CCCM: "000000"
+CCCM: "000006"
AT+CAOC
3-56
•In IDLE state - returns the last call cost.
•In a voice/data state - returns the accumulated cost, including the current call.
Syntax
+CAOC[=<mode>]
+CAOC?
+CAOC
+CAOC=?
Table 3-26: +CAOC Parameters
0 Queries the CCM value
1 Deactivates unsolicited reporting of the CCM value
2 Activates unsolicited reporting of the CCM value
<CCM>: String type value representing three bytes of the current call meter value in
hexadecimal format (for example, "00001E" indicates decimal value 30).
AT Commands Reference Manual
Response/Action
The Set command returns the CCM
OK
value from the G24, or
or:
activates/deactivates unsolicited
[+CAOC:<ccm>]
reports.
or:
+CME ERROR:<err>
+CAOC: <mode> The Read command returns the current
CAOC mode.
OK
OK
or:
[+CAOC: <ccm>]
or:
+CME ERROR: <err>
+CAOC: (list of The Test command returns the
supported mode values.
supported <mode>s)
OK
Description
Remarks
December 31, 2007