Motorola G24 Guide Developer's Manual page 322

Audio
The following diagram shows the audio paths:.
Input
Input voice
Output
Figure 3-7: Audio Paths
Command
Type
Set
Read
Test
3-238
H andset Microphone
H eadset Microphone
H andset Microphone
H eadset Microphone
Syntax Response/Action
+MAPATH= OK
<direct>,<accy>
or:
[,<features>]
+CME ERROR: <err>
+MAPATH? +MAPATH:1(mode
in),<accy>
+MAPATH:2(mode out),
<accy>,<feature>
[<CR><LF>+MAPATH:2
(mode out),
<accy>,<feature>
[...]]
OK
+MAPATH=? +MAPATH: (list of
supported directions),(list
of supported
accessories),(list of
supported features
combinations)
OK
AT Commands Reference Manual
Voice
H eadset Speaker
Voice
H andset Speaker
A lert/R inger
A lert Transducer
H eadset S peaker
H andset Speaker
A lert Transducer
The Set command sets the audio path
mode. The mode indicates which I/O
accessories are now active for the different
audio features. The <features> field is
only used for outputs (direct=1).
The Read command returns the active
input audio accessory and the output
accessory for each feature.
The Test command returns the supported
audio directions (input/output),
accessories and features.
Features:
• Voice • Voice
• Key feedback •
• Alert • Alert
• Ring • Ring
Remarks
December 31, 2007