Motorola G24 Guide Developer's Manual page 102

Call Control
Single Active and Waiting Call
MTPY Active and Waiting Call
Single Held or MTPY Held
Single (or MTPY) Active and Single (or
MTPY) Held
Held (Single or MTPY) and Waiting Call
Single (or MTPY) Active and Single (or
MTPY) Held & Waiting call
Example
RING//Incoming call
RING //Incoming call
ath //Hang-up incoming call
NO CARRIER
OK
RING
ata
OK //Voice call connected
ath //Hang-up connected call
NO CARRIER
OK //Active call has been hung-up - terminated
(... Active multi party call, with 3 numbers ...)
ath
NO CARRIER
NO CARRIER
NO CARRIER
OK
atd035659260;
OK
ath //Terminate MO voice call while placed
NO CARRIER
OK
Example - Hanging up a data call:
atd035659260
CONNECT//Data call connected - Online Data mode
...
+++ //ESC Sequence is sent from the terminal to the G24
OK //The G24 is in Command mode
ath //Terminate Data call
NO CARRIER
OK
3-18
Call State
//Incoming call has been terminated - user determined user busy
AT Commands Reference Manual
Response/Action
Single Active released (waiting not affected)
MTPY Active released (waiting not affected)
Error 3
Single (or MTPY) Active released
Waiting call released
Single (or MTPY) Active released
December 31, 2007