General Audio Commands; Basic Audio Setup Commands; Crsl, Call Ringer Level - Motorola G24 Guide Developer's Manual

Audio
G24 supports both analog and digital audio. Digital audio is supported in both basic and advanced
audio setups. Switching between analog and digital audio modes is done by AT+MADIGITAL
command. The default state is analog.
Figure 3-6: Analog/Digital Switching

General Audio Commands

The following audio commands can be used in both Basic and Advanced audio modes.
General audio commands are: +CRTT, +VTD, +VTS, +CALM, +MMICG, +MADIGITAL.

Basic Audio Setup Commands

+CRSL, Call Ringer Level

This command handles the selection of the incoming call ringer and alert tone (SMS) sound level
on the alert speaker of the G24. The new value remains after power cycle. This command has no
affect on digital audio mode.
Command Type
Set
Read
Test
3-232
Power Up
A T+MA D IGITA L=1
Syntax Response/Action
+CRSL=<level> OK
+CME ERROR: <err>
+CRSL? +CRSL: <level>
+CME ERROR: <err>
+CRSL=? +CRSL: (list of
supported <level>s)
+CME ERROR: <err>
AT Commands Reference Manual
Analog
A T+MA D IGITA L=0
Digital
The Set command sets the call ringer
and alert (SMS) level.
The Read command displays the
current ringer alert (SMS) sound level
setting.
The Test command displays the list of
supported sound level settings.
Remarks
December 31, 2007