Ftm, Transmit Data - Motorola G24 Guide Developer's Manual

Fax Class 1
The following table shows the +FRS parameters.
Example
At+fclass=1
OK
Atd035658584
CONNECT 9600
OK
At+frs=50
OK //The G24 sends the OK after silence for 10*50 milliseconds

+FTM, Transmit Data

This command causes the G24 to transmit data to the remote party using the modulation selected
in <MOD>. The G24 sends the data stream received from the terminal without any framing.
Transmission Using the Transparent Data Command
The DLE character, (0x10), is used as a special character to precede command characters. The
character pairs <DLE><command> are used to convey commands or status information between
the terminal and the G24.
•
Terminal to G24 streams (Encoding)
–
When the terminal needs to send a <DLE> character in the data stream, it sends two
–
When the terminal needs to send two sequential <DLE> characters in the data stream, it
–
When the terminal sends the terminator sequence <DLE> <ETX>, the data stream is
•
G24 to terminal streams (Decoding):
–
The terminal decodes the input stream and removes all character pairs beginning with
–
The terminal recognizes <DLE><ETX> as the data stream terminator.
–
The terminal recognizes and replaces <DLE><DLE> by a single <DLE> in the data stream.
–
The terminal recognizes and replaces <DLE><SUB> by a single <DLE><DLE> in the data
When the G24 receives the +FTM command, it immediately returns an OK result code. When the
terminal receives the OK from the G24, it can start sending the data stream using the transparent
data command encoding. When the G24 decodes the terminating sequence, it returns a
CONNECT.
3-426
Table 3-283: +FRS Parameters
<Parameter>
<Time>
sequential <DLE> characters to the G24.
sends the <DLE><SUB> characters instead.
terminated.
<DLE>.
stream.
AT Commands Reference Manual
Description
The duration of the silence, in 10 millisecond intervals.
0-255 Number of milliseconds.
December 31, 2007