Motorola G24 Guide Developer's Manual page 79

AT Command
+CLCC
+CLVL
+CMEE
+CMER
+CMGF
+CMUX
+CNMI
+CPAS
+CPIN
+CRC
+CRSM
+CRTT
+CSDH
+CSMP
+CSQ
+EMPC
+EPIN
+FMI
+FMM
+FMR
+GCAP
+GMI
December 31, 2007
Table 2-1: Core AT Commands (Cont.)
Description
This command displays a list of all current G24 calls and their
statuses, and also enables/disables the unsolicited indication of the
call list.
This command sets the volume of the internal loudspeaker of the
G24.
This command enables/disables the use of result code +CME
ERROR: <err> as an indication of an error relating to the
functionality of the G24.
This command enables an external accessory to receive key press
information from the G24's internal keypad.
This command handles the selection of message formats.
This command is used to enable/disable the GSM MUX
multiplexing protocol stack.
This command sends an unsolicited indication when a new SMS
message is received by the G24.
This command displays the current activity status of the G24, for
example, call in progress, or ringing.
This command is only relevant for phones that use SIM cards. It
unlocks the SIM card when the proper SIM PIN is provided, and
unblocks the SIM card when the proper SIM PUK is provided.
This command controls whether to present the extended format of
the incoming call indication.
This command provides limited access to the Elementary Files on
the SIM.
This command plays one cycle of a ring tone, stops the cycle in the
middle, and sets the ring tone to be used.
This command controls whether detailed header information is
shown in text mode result codes.
This command sets the Text Module parameters.
This command returns the signal strength received by the G24.
This command unlocks or resets the first PLMN of the
inserted SIM.
This command is only relevant for phones that use SIM cards. It
verifies the PIN2 indicator.
This command displays manufacturer identification.
This command displays the model identification.
This command displays the revision identification.
This command requests the overall capabilities of the G24.
This command requests manufacturer identification. The command
is not supported when the SIM is missing.
AT Commands Reference Manual
Chapter 2: Introduction to AT Commands
Page
Page 3-47
Page 3-233
Page 3-289
Page 3-314
Page 3-101
Page 3-438
Page 3-107
Page 3-46
Page 3-253
Page 3-19
Page 3-302
Page 3-247
Page 3-106
Page 3-104
Page 3-167
Page 3-262
Page 3-256
Page 3-1
Page 3-2
Page 3-3
Page 3-197
Page 3-1
2-11