Mceg, Motorola Control Egprs - Motorola G24 Guide Developer's Manual

GPRS/EDGE

+MCEG, Motorola Control EGPRS

This AT command is used to enable or disable EGPRS support in G24 modules with EDGE
support capability.
The command works only in G24 customer models with EDGE capability. The phone restarts 10
seconds after the SET command execution completed. The changes take effect after restart.
Command
Type
Set
Read
Test
The following table shows the +MCEG parameters.
<Parameter>
<n>
Example
AT+MCEG=?
+MCEG: (0-1)
OK
AT+MCEG=0
OK
AT+MCEG?
+MCEG: 0
OK
AT+MCEG=1
OK
AT+MCEG?
+MCEG: 1
OK
3-356
Syntax
AT+MCEG=<n> OK
or:
+CME ERROR: <err>
AT+MCEG? + MCEG : <n>
OK
or:
+CME ERROR: <err>
AT+MCEG=? + MCEG : (0-1)
OK
or:
+CME ERROR: <err>
Table 3-227: +MCEG Parameters
Indicates the EGPRS support state (enabled or disabled)
0 Disable EDGE support.
1 Enable EDGE support.
AT Commands Reference Manual
Response/Action
Description
Remarks
The SET command used
for setting the current
EGPRS support state.
The READ command
returns the current
EGPRS support state
<n>.
The Test command
returns the possible
values' range.
December 31, 2007