H, Hang-Up Call - Motorola G24 Guide Developer's Manual

Example
atdl //Last called number is "035658278"
ATDL: "035658278"
OK //DATA call
atdl;
ATDL: "035658278"
OK
OK //VOICE call
atdl //Last called number is "035658278,123,78;"
ATDL: "035658278"
CONNECT //DATA call
atdl; //Last called number is "035658278,123,78"
ATDL: "035658278p123p78"
OK
OK //VOICE call
1 2 3 //Sent as DTMF tones
... //Pause
7 8 //Sent as DTMF tones

H, Hang-up Call

This command hangs up a call. The G24 terminates the call whether it is a data or voice call, and
whether it is an incoming, originating, waiting, or connected call.
A NO CARRIER message is returned to the terminal before the regular OK approval.
Note:
The following table shows the call states of the H command.
IDLE
Single Active
MTPY Active
Incoming call (RING)
December 31, 2007
•ATDL; (Voice) dials the exact number that was last dialed, including the DTMF tones
sent.
•ATDL (Data/Fax) dials the addressing information only (comma and tones are
discarded).
•If ATDL is sent before any Dial command was issued (mainly after Power On, when the
last number is an empty field), the G24 will return NO CARRIER, as mentioned in the
ITU V.25-ter standard.
To terminate (hang-up) a MO data/fax call while call is placed: Any character sent from
the terminal to the G24 causes the Data/Fax call termination, and NO CARRIER is sent
from the G24 to the terminal.
To terminate a held Voice call or to terminate a call out of a MTPY call, refer to
Call Related Supplementary Services Command" on page
Call State
AT Commands Reference Manual
Chapter 3: AT Commands Reference
3-25.
Response/Action
Error 3 ("operation not allowed") or OK, depending
on a FLEX bit
Call released
Call released (all calls)
Call released
"+CHLD,
3-17