Motorola G24 Guide Developer's Manual page 363

Example
ATS36?
005
OK
ATS0=3
OK
ATS0?
003
OK
S2
This command handles the selection of the escape characters, which are stored in S-Register 2,
and specifies the escape character used in CSD connections.
Command
Type
Set
Read
The following table shows the S2 parameters.
<Parameter>
<escape_character>
December 31, 2007
Syntax Response/Action
S2=<escape_character> OK
+CME ERROR: <err>
S2? <escape_character>
OK
+CME ERROR: <err>
Table 3-185: S2 Parameters
CSD escape character.
Range is 0 to 255. The default value is 43 ("+").
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Remarks
The Set command sets the CSD escape
character value if all parameters are
valid.
The Read command displays the
currently defined escape character for
CSD connections.
Description
3-279