Mipconf - Configure Internal Tcp/Ip Stack - Motorola G24 Guide Developer's Manual

MIPCONF - Configure Internal TCP/IP stack

This command allows to configure TCP stack parameters, such as retransmissions number, upper
and bottom limits of retransmission timeout, close delay. It can be used to configure TCP socket
parameters before socket activation or when the socket is in active state. Configuration values
will be stored in G24 until power circle.
Command Type
Set
Read
Test
Parameter
< socket >
< retr_num >
< min_TO >
<max_TO>
December 31, 2007
Syntax
AT+MIPCONF=< OK
socket>[,[<retr_n
or:
um>],[<min_TO>
+CME ERROR: <err>
],[<max_TO>],[<
max_close_delay>
][,<is_nack_ind_r
eq>]]
+MIPCONF? +MIPCONF:
1,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
2,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
3,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
4,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
+MIPCONF=? +MIPCONF:
(1-4),(1-5),(1-10),(10-600),(1-75),(0-2)
Table 3-272: +MIPCONF Parameters
Number of configured TCP socket (1 to 4)
Number of retransmissions (1 to 5)
Bottom limit to retransmit timeout (100 ms to 1 sec.)
Upper limit to retransmit timeout (1 sec. to 60 sec.)
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Response/Action
Description
Remarks
The Set updates TCP
stack configuration
parameters.
he read command
returns current
settings of TCP stack
parameters.
The Test command
returns the possible
parameters values.
Time values can be
inserted with
resolution of 100
milliseconds.
3-403