Motorola G24 Guide Developer's Manual page 237

6. If the operation (send or receive) will proceed, or not, after security warning alert presence.
Note:
Command
Type
Set
Read
Test
The following table shows the +MEMGS parameters.
<Parameter>
<save_srv>
<size>
<auto_sign>
December 31, 2007
+MEMGS parameters are saved after the power cycle.
Syntax
AT+MEMGS=[<save_srv>[,
<size>
[,<auto_sign>],[
security_ssl_sending],[
security_ssl_receiving],[
security_warning_backgrou
nd_process]
AT+MEMGS?
AT+MEMGS=?
Table 3-92: +MEMGS Parameters
Allows the user to retain a copy of the messages on the server, default value is 0
which means messages will be saved on server after downloading.
Possible values:
0 - Save on server
1 - Delete from server
Incoming email size restriction. The default is 10240 byte. The range is 0-65535. 0 is
a valid value. In this case device will not receive email messages.
Auto signature. String field for entering auto signature information. The maximum
length is 100 characters. Auto signature will be added to email body when ever it
exist.
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Response/Action
OK
Or:
+CME ERROR: <err>
+MEMGS=<save_srv>,<si
ze>,<auto_sign>>,<securit
y_ssl_sending>,<
security_ssl_receiving>,<
security_warning_backgro
und_process>
OK
+MEMGS: list of
supported <save_srv>s
values, list of supported
<size>s values, maximum
allowed length of
<auto_sign>, list of
supported <
security_ssl_sending>s
values, list of supported <
security_ssl_receiving >s
values,
list of supported <
security_warning_backgro
und_process>s values
OK
Description
Remarks
3-153