Motorola G24 Guide Developer's Manual page 474

GPRS/EDGE
Command Type
Set
Read
Test
3-390
SSL connection is not supported for listening sockets.
Syntax
AT+MIPODM=
<Socket ID>,
<Source Port>,
<Remote IP>,
<Remote Port>,
<Protocol>,<Pseu
do-Command
Mode On/Off>
AT+MIPODM?
AT+MIPODM=?
AT Commands Reference Manual
Response/Action
OK
or:
+MIPODM: <Socket
ID>,<State>[,<Remote IP>,<Remote
Port>]
or:
+MIPSTAT: <Socket ID>,<Status>
or:
ERROR: <err>
+MIPODM:[<SocketID>]
for each socket that can be opened
or:
+MIPODM 0,0
if there are no free sockets.
+MIPODM: (list of supported
<socket ID>s),(list of supported
<source port>s),(list of
supported<"Destination IP">s),
(list of <destination port>s),(list of
supported <protocol>s), (list of
supported <Pseudo-Command
Mode state>s)
Remarks
The Set command returns
<Remote IP> and
<Remote Port>
parameters only for
sockets opened in Listen
mode.
When a socket opens in
Online Data Mode, the
command returns actual
Socket ID value and '1'
value (active). G24 will
be in pseudo-command
mode for receiving the
command.
December 31, 2007