Hardware Information
Operation of this command is flex dependent.
Command
Type
Set
Read
Test
The following table shows the +TASW parameters.
<Parameter>
<ant>
Example
AT+TASW=?
+TASW: (1,2)
OK
AT+TASW?
+TASW: 1
OK
AT+TASW=2
OK //Power-cycle the phone
AT+TASW?
+TASW: 2
OK
+TADIAG, Query Antennas ADC Value
This command is intended for use in automotive applications which include hardware support of
two antennas; primary antenna for regular use, and secondary antenna for emergency use.
This command returns the current ADC values for both antennas. These values represent the DC
voltage levels of the connected antennas, based on the antennas DC load resistance.
3-210
Syntax
Response/Action
AT+TASW=<ant>
OK
or:
ERROR
AT+TASW?
+TASW:<ant>
or:
ERROR
AT+TASW=?
+TASW: (Supported
<ant>s)
or:
ERROR
Table 3-137: +TASW Parameters
1
Primary antenna (default value).
2
Secondary antenna.
AT Commands Reference Manual
Remarks
Set active antenna.
Read the antenna selection.
Supported antennas.
Description
December 31, 2007