Motorola G24 Guide Developer's Manual page 338

Access
Command
Type
Set
Read
Test
The following table shows the +CPIN parameters.
<Parameter>
<puk>
<pin>
<newpin>
<code>
SIM PIN
SIM PUK
SIM PUK2
SIM PIN 2
3-254
Syntax Response/Action
AT+CPIN=[<puk> OK
or <pin>],
or:
[<newpin>]
+CME ERROR: <err>
AT+CPIN? +CPIN: <code>
OK
or:
+CME ERROR: <err>
AT+CPIN=? OK
or:
+CME ERROR: <err>
Table 3-169: +CPIN Parameters
PUK code for unblocking a blocked phone
Current PIN for unlocking a locked phone
New PIN (after changing or after entering PUK) 4 - 8 digits
READY - Not waiting for a password
SIM PIN - Waiting for SIM PIN
SIM PUK - Waiting for SIM PUK
SIM PIN2 - Waiting for SIM PIN, this response is given when the last executed
command resulted in PIN2 authentication failure
SIM PUK2 - Waiting for SIM PUK2, this response is given when the last executed
command resulted in PUK2 authentication failure
AT+CPIN=<pin>
AT+CPIN=<puk>,<newpin>
AT+CPIN=<puk2>,<newpin2>
AT+CPIN=<pin2>
AT Commands Reference Manual
Remarks
The Set command sends the password to
the G24 that is necessary before it can be
operated (SIM PIN or SIM PUK). If there
is no PIN request pending, no action is
taken towards the G24, and an error
message, +CME ERROR, is returned to
the terminal.
The Set command issued gives the code
(SIM PIN or SIM PUK) corresponding to
the error code required or returned as the
result of the Read command. For example,
if the SIM PIN is blocked, the error code
11 or "SIM PIN required" is returned. The
user must then issue the Set command with
the SIM PIN.
The Read command returns an
alphanumeric string indicating the status
of the SIM card, and whether a password is
required or not. This is an independent
SIM card lock status check only, and does
not check the phone lock status.
Description
December 31, 2007