S24, Set Number Of Seconds Delay Before G24 Enters Sleep Mode - Motorola G24 Guide Developer's Manual

Two modes exist:
•
Idle mode: The G24 has no data to send.
•
Wakeup mode: The G24 has data to send to the terminal.
After the G24 changes the line edge to Wakeup mode, there will be a delay (the default is 30 ms)
sent by the ats102 command before sending any data to the terminal (using RS232 protocol).
WA K EU P-IN
Terminal TXD
G24
Sleep mode
(C lock)
G 24 C TS
(D efault w hen
at+mscts=0)
Figure 3-12: Sleep Mode when S24 > 0
WA K EU P-OU T
G24 TXD
Figure 3-13: G24 Lines when S24 > 0

S24, Set Number of Seconds Delay Before G24 Enters Sleep Mode

This command activates/disables the Sleep mode. The terminal sends ATS24=5, and if there are
no radio and UART activities, the G24 enters sleep mode in 5 seconds.
If terminal has some indication of the CTS pin activity, it can see:
•
If +MSCTS=0 (default), the line changes its state periodically. (For more information refer
to
•
If +MSCTS=1, the line is switched off at the moment of entering Sleep mode and stays off
even if G24 is awakened.
December 31, 2007
30 ms
Awake
Sleep
S102
"+MSCTS, Enable/Disable CTS During Wakeup Period" on page
AT Commands Reference Manual
Chapter 3: AT Commands Reference
30 ms
S24 Less than S24
S102
S24
3-288.)
3-285