Motorola G24 Guide Developer's Manual page 591

+MGGIND
+MHDPB
+MHUP
+MIAU
+MIOC
+MIOD
+MIPCALL
+MIPCFF
+MIPCLOSE
+MIPCONF
+MIPCSC
December 31, 2007
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command
This command configures the
service indicator on pin 49 of the
70 pin connector to be GPRS or
GSM.
This command is used to enable
and disable the SEND/END
functionality of the headset
dual-position button.
This command Hung UP call(s)
and report specific cause to the
NW.
This command manages IP
Director addresses and port.
This command defines the
G24 8 GPIO pins data value.
This command defines the
G24 8 GPIO pins
configuration.
This command creates a wireless
PPP connection with the GGSN,
and returns a valid dynamic IP
for the G24.
This command allows
configuring the incoming TCP
connection filtering feature
parameters, such as list of
allowed IP addresses or
disabling/enabling the filtering.
This command causes the G24
module to free the socket
accumulating buffer and
disconnect the G24 from a
remote side.
This command allows to
configure TCP stack parameters,
such as retransmissions number,
upper and bottom limits of
retransmission timeout, close
delay.
This AT command is used to
configure the SSL feature
behavior in case of non - fatal
alerts.
AT Commands Reference Manual
Appendix A: Reference Tables
Description
Page 3-203
Page 3-318
Page 3-42
Page 3-338
Page 3-213
Page 3-217
Page 3-386
Page 3-417
Page 3-392
Page 3-403
Page 3-414
Page
A-15