Mdmic, Enable/Disable Microphone Level Setting In Digital Audio Mode; Mmicg, Microphone Gain Value - Motorola G24 Guide Developer's Manual

Audio
+MDMIC, Enable/Disable Microphone Level Setting in Digital Audio
Mode
This command Enables/Disables the setting of the microphone level in digital audio mode via
+MMICG command.
Note:
Command
Type
Set
Read
Test
The following table shows the +MDMIC parameters.
<Parameter>
<Mode>

+ MMICG, Microphone Gain Value

This command handles the selection of microphone gain values of MIC-handsets (not
MIC-headsets). The new value remains after power cycle. This command affects in digital audio
mode, only when +MDMIC command is used to enable the microphone setting.
Command
Type
Set
3-246
Do not change +MDMIC settings during an active voice call.
Syntax
AT+MDMIC=<Mode>
AT+MDMIC?
AT+MDMIC=?
Table 3-162: +MDMIC Parameters
0 - Disables the control of microphone level setting in digital audio mode via
+MMICG. i.e. microphone level setting will not be affected by +MMICG.
This is the default value when +MDMIC set command is never used.
1 - Enables the control of microphone level setting in digital audio mode via
+MMICG. i.e. microphone level setting will be affected by +MMICG.
Syntax
+MMICG=<gain>
AT Commands Reference Manual
Response/Action
OK
Or:
+CME ERROR: <err>
+MDMIC: <mode>
OK
+MDMIC: (list of
supported <modes>)
OK
Description
Response/Action
OK The Set command sets the microphone
gain value.
+CME ERROR: <err>
Remarks
<Mode> is saved after power down.
Remarks
December 31, 2007