Clcc, List Current Calls - Motorola G24 Guide Developer's Manual

+CPAS: 4
OK
AT+CPAS//Voice call active state
+CPAS: 4
OK

+CLCC, List Current Calls

This command displays a list of all current G24 calls and their statuses, and also enables/disables
the unsolicited indication of the call list. (If no calls are received, no information response is sent
to the terminal.)
If the command succeeds but no calls are available, no information response is sent to the
terminal.
The maximum number of simultaneous multiparty calls is 5+1 (5 in active group and 1 on hold).
Command
Type
Set
Execute
Read
Test
December 31, 2007
Syntax Response/Action
AT+CLCC=<state> OK
or:
+CME ERROR: <err>
AT+CLCC +CLCC: <idx>,<dir>,<call
state>, <mode>,
<mpty>[,<number>,<type>,
<alpha>]
[<CR><LF>+ CLCC:
<idx>,<dir>,<call state>,
<mode>,<mpty>[,<number>
,<type>,<alpha>]
[...]]
OK
AT+CLCC? +CLCC: <state>
OK
or:
+CME ERROR <err>
AT+CLCC=? +CLCC: (List of supported
<state>s)
OK
or:
+CME ERROR <err>
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Remarks
The Set command enables/disables
unsolicited indications.
The Execute command enables
the receiving of data about
current calls.
The Read command returns the call
status.
3-47