Motorola G24 Guide Developer's Manual page 595

+MTTY
+MUPB
+MVC
+MVREF
+TADIAG
+TASW
+TCLCC
+TPIN
+TSMSRET
+TWUR
+TWUS
+VTD
+VTS
A
A/
December 31, 2007
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command
This command is used to
enable/disable the TTY (Tele
Typewriter) support in the G24.
This command causes the G24 to
send an event when a phone book
entry is accessed or modified by
the user.
This AT command is used to
choose and configure the
priority order of the supported
voice codecs (vocoders).
This command defines the
behavior of Vref regulator.
This command queries actual
ADC values of the antennas.
This command controls the
antenna switch mechanism.
This command displays a list of
all current G24 calls and their
statuses, and also
enables/disables the unsolicited
indication of the call list.
This command queries the
number of remaining SIM
PIN/PUK entering attempts.
This command controls the SMS
sending retry.
This command is used to query
the wakeup reason(s).
This command is used to set the
wakeup reason(s).
This command handles the
selection of tone duration.
This command transmits DTMF
tones when a voice call is active.
This command answers an
incoming call, placing the G24
into the appropriate mode, as
indicated by the RING message.
This command repeats the last
command entered on the
terminal.
AT Commands Reference Manual
Appendix A: Reference Tables
Description
Page 3-44
Page 3-322
Page 3-43
Page 3-227
Page 3-210
Page 3-209
Page 3-51
Page 3-257
Page 3-142
Page 3-209
Page 3-207
Page 3-250
Page 3-251
Page 3-19
Page 3-252
Page
A-19