Motorola G24 Guide Developer's Manual page 351

Upon the receiving of the AT+MFOTACNFG command, the module will perform the following
tasks:
1. Validate OMA-status is "idle" and DM-session is not active. If not, the module will abort the
command with a CME error "operation not allowed" (code 3).
2. Otherwise - set the appropriate Flex params, return OK to DTE.
Command
Type
Set
Read
Test
The following table shows the +MFOTACNFG parameters.
<Parameter>
<Automaitc DM
session>
Example
AT+MFOTACNFG?
+MFOTACNFG: 0
OK
AT+MFOTACNFG=1
OK
AT+MFOTACNFG? ?
+MFOTACNFG: 1
OK
December 31, 2007
Syntax
AT+MFOTACNFG= <OK>
or:
<Automatic DM session> +CME ERROR:
<"operation not
allowed">
AT+MFOTACNFG? +MFOTACNFG:
<Automatic DM session>
AT+MFOTACNFG =? +MFOTACNFG : list of
<Automatic_DM_Mode>
Table 3-176: +MFOTACNFG Parameters
Description
0 - Non automatic DM session
1 - Automatic DM session
// Get the FOTA DM session mode
// change the FOTA DM session mode to Non-Automatic
// Get the FOTA DM session mode
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Response/Action
Enable/Disable FOTA feature at
the selected DM mode.
Provide FOTA session state.
"Automatic DM Session"
enables the network to contact
and establish a secure
connection with the modem
without direct user interaction.
Remarks
Remarks
3-267