Saving A Changed Configuration - AT&T Call Management System Supervizor's Manual

Programming CMS Shift Configurations

Saving a Changed Configuration

When you build a new shift configuration or make changes in an existing one,
the word
(changed)
configuration number. You can store the last edited configuration in a previ-
ously unused configuration or store it in place of another configuration.
For example, you could change configuration 1 and replace the original with
the updated copy. If you want to keep the original shift 1 configuration as
well as the updated copy, you can store the copy in an unused configuration
number by following the procedure outlined below.
1. From the Configuration screen, press [F7] (Config List).
The Stored Shift Configurations screen (Figure
2. Press [F2] (Save Config) on the Stored Shift Configurations screen.
The word (changed) appears next to the configuration you last edited and
the prompt appears as follows:
SAVE CONFIGURATION :
3. Press [F8] (Enter Data) to save the edited configuration under the same
configuration name and number as the original (in other words, to
replace the original with the updated copy).
or
Enter a configuration number and press [F8] (Enter Data) to save the
edited configuration under a different configuration number.
The prompt appears
SAVE CONFIGURATION :
NAME? (Y/N): —
where x is
The number and name of the configuration you changed appears in this
prompt.
3-30 Saving a Changed Configuration
appears on the configuration list to the left of the
Into Config #: _
as
follows:
Replace Contents of Config X -\
a
number 1 through
3-9)
6 NAME is
and the name of the configuration.
appears.